Differences

This shows you the differences between two versions of the page.

--- notes:over [2016/02/01 16:16]
over23
+++ notes:over [2016/03/06 20:25] (current)
over23 [Headline]
@@ Line 1: / Line 1: @@
 ====== Headline ======
-  * notes:icnd2-study-guide.pdf
+  * [[https://labka.cz/wiki/lib/exe/fetch.php?media=notes:cisco_icnd1_100-101.pdf|cisco_icnd1_100-101.pdf]]
-  * notes:5-ciscolab_-_tcp_and_udp_wireshark.doc
+  * notes:ccnp-switch.pdf
-  * notes:cisco_ccna_routing_and_switching_icnd2_200-101.pdf
+  * notes:icnd1.zip
-  * notes:cisco_icnd1_100-101.pdf
+  * [[https://labka.cz/wiki/lib/exe/fetch.php?media=notes:icnd2-study-guide.pdf|icnd2-study-guide.pdf]]
+  * [[https://labka.cz/wiki/lib/exe/fetch.php?media=notes:5-ciscolab_-_tcp_and_udp_wireshark.doc|5-ciscolab_-_tcp_and_udp_wireshark.doc]]
+  * [[https://labka.cz/wiki/lib/exe/fetch.php?media=notes:cisco_ccna_routing_and_switching_icnd2_200-101.pdf|cisco_ccna_routing_and_switching_icnd2_200-101.pdf]]
+  * to.pe cz.verizon.
+  * http://www.cs.vsb.cz/grygarek/SPS/lect/VLSM/VLSM.html
+  * subnetiitng: http://www.edaboard.com/thread156595.html
+  * subneting - binary logic: http://www.garykessler.net/library/subnet_masks.html
+===== Switch =====
+  * enable
+  * configure terminal [conf t]
+  * show run
+  * copy run start
+  ** write memory
+  * erase startup
+ * sh ver [C3560 - c2 = L2 switch, C3xxxx = L3]
+===== 2 =======
+  * enable
+  * conf t
+  * show run
+  * ip rout [udelas ze switche L3 router]
+  * no ip rout [udelas zase switrch]
+  * do sh run [do dela to, ze funguje i v config mode, jinak jen v eneable, nefunguje tab]
+  * do show vlan
+  * show interfaces fa0/1 [L1 funkcionalita]
+  * show interfaces fa0/1 switchport [L2 funkcionalita]
+  * switchport  trunk encapsulation ?
+  * switchport mode trunk
+  * do show interface fa0/14 sw
+  * vlan 40
+  * vlan 41
+  * do show vtp [vtp protkokol uci vlany ostatni switche]
+===== notes =====
+chapter 9 [doucit chapter 7-8]