Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
project:nodemcu_windev:en [2017/03/11 23:50] licho [Upload NodeMCU firmware] |
project:nodemcu_windev:en [2017/03/11 23:52] licho [Upload NodeMCU firmware] |
||
|---|---|---|---|
| Line 23: | Line 23: | ||
| In guide [[nodemcu_lbe:en|Linux Firmware Build Environment]] we went through steps how to compile nodeMCU firmware. Now we need upload firmware into ESP8266. For this purpose are available virious scripts and programs on the internet. Here we describe tool for Windows written in Delphi[[https://github.com/nodemcu/nodemcu-flasher|NodeMCU-Flasher]]. | In guide [[nodemcu_lbe:en|Linux Firmware Build Environment]] we went through steps how to compile nodeMCU firmware. Now we need upload firmware into ESP8266. For this purpose are available virious scripts and programs on the internet. Here we describe tool for Windows written in Delphi[[https://github.com/nodemcu/nodemcu-flasher|NodeMCU-Flasher]]. | ||
| - | Enable ''FLASH'' mode before start uploading firmware . Flash mode can be enabled by pushing ''FLASH'' button on nodeMCU or before reboot set ''GPIO0'' pin to ''LOW''. [[https://labka.cz/wiki/doku.php?id=project:nodemcu:en#important_warnings|Important warnings]] | + | Enable ''FLASH'' mode before start uploading firmware. Flash mode can be enabled by pushing ''FLASH'' button on nodeMCU or before reboot set ''GPIO0'' pin to ''LOW''. [[https://labka.cz/wiki/doku.php?id=project:nodemcu:en#important_warnings|Important warnings]] |
| ==== ESP8266 Flasher Tool ==== | ==== ESP8266 Flasher Tool ==== | ||