Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
project:laser_modulation [2015/12/16 20:02] ivan_ahepjuk [Main solution:] |
project:laser_modulation [2015/12/23 19:13] ivan_ahepjuk [Main solution:] |
||
---|---|---|---|
Line 5: | Line 5: | ||
**Introduction:** | **Introduction:** | ||
- | Hopefully there will not be big fails. Still, It would be challenge to tune and tweak the concept and build robust design. I would like to use green laser, because i got it at home and I think that its strong enough to transfer from my rooftop to the Ema hill. | + | Hopefully there will not be big fails. Still, It would be challenge to tune and tweak the concept and build robust design with using as little parts as possible. I would like to use green laser, because i got it at home and I think that its strong enough to transfer from my rooftop to the Ema hill. |
* **step 0:** Think, ask and read how to use laser beam to transfer sound frequencies. Think how to receive this kind of information. Understand the principles. | * **step 0:** Think, ask and read how to use laser beam to transfer sound frequencies. Think how to receive this kind of information. Understand the principles. | ||
Line 22: | Line 22: | ||
**2]** It would be pain in the ass to calibrate this and it would change with "each blow of the wind". There are better way and they are called modulation. | **2]** It would be pain in the ass to calibrate this and it would change with "each blow of the wind". There are better way and they are called modulation. | ||
- | * **Pulse-Frequency Modulation**: The main idea is to make laser flashing at the frequency, which I am actually transmitting. In the other words, instead of transmitting sinus of the frequency X, I can transmitt pulse signal of the frequency X and then, after receiving this pulse signal of the frequency X, just make the sinus from it by analog filters. | + | * **Pulse-Width Modulation**: The main idea is to make laser flashing at certain frequency and while transmitting, be changing the width of pulses by the transmitted frequency |
+ | * https://en.wikipedia.org/wiki/Pulse-width_modulation. | ||
- | + | **Step 1:** Initial design: This is basic idea how to build the transmitter. | |
- | **Step 1:** Initial design: | + | |
* All amplifiers are LM358N | * All amplifiers are LM358N | ||
+ | Cannot upload pictures:/ | ||
- | **Step 2:** simulation by LTspice | ||
- | |||
- | **Step 3:** Stay tuned | ||
+ | **Step 2:** simulation by LTspice (maybe little tutorial how to use ltspice would be more than good) | ||
+ | Cannot upload pictures:/ | ||
+ | **Step 3:** Photo of actual prototype | ||
+ | Cannot upload pictures:/ | ||
+ | **Step 4:** stay tuned | ||