Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
project:amiga_ps2usb_mouse:amiga_usb_ps2_mouse [2021/08/19 18:47] cyberian [PICkit v3.5 - programming kit] |
project:amiga_ps2usb_mouse:amiga_usb_ps2_mouse [2021/08/27 16:22] cyberian References |
||
---|---|---|---|
Line 20: | Line 20: | ||
I used for programming SW: MPLAB X IDE v5.50. In setup choose MPLAB IPE as this part of SW is intended as standalone simple application for programming. | I used for programming SW: MPLAB X IDE v5.50. In setup choose MPLAB IPE as this part of SW is intended as standalone simple application for programming. | ||
- | There can be some issues. For example I used previously some programming adapter connected to PICkit. Jumper was set correctly, but PIC MCU had higher temp and I got error: Target Device ID (0x3fe0) is an Invalid Device ID. Please check your connections to the Target Device. After several hours of suffering and finding the cause of the problems, I gave up on the adapter and connected the MCU to the breadboard. | + | There can be some issues. For example I used previously some programming adapter connected to PICkit. Jumpers were set correctly, but PIC MCU had higher temp and I got error: Target Device ID (0x3fe0) is an Invalid Device ID. Please check your connections to the Target Device. After several hours of suffering and finding the cause of the problems, I gave up on the adapter and connected the MCU to the breadboard. |
The right log from programming is following: | The right log from programming is following: | ||
Line 54: | Line 54: | ||
Blank Checking was clicked additionally just for sure :) | Blank Checking was clicked additionally just for sure :) | ||
+ | |||
+ | ===== References ===== | ||
+ | Thx to Henryk Richter from http://bax.comlab.uni-rostock.de/en/hardware/ps2-amiga-maus/ | ||
+ |