Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
project:amiga_ps2usb_mouse:amiga_usb_ps2_mouse [2021/08/19 18:31] cyberian [PICkit v3.5 - programming kit] |
project:amiga_ps2usb_mouse:amiga_usb_ps2_mouse [2021/08/27 16:22] cyberian References |
||
|---|---|---|---|
| Line 18: | Line 18: | ||
| |**6** not con. | not connected | | |**6** not con. | not connected | | ||
| {{ :project:amiga_ps2usb_mouse:pickit_pic16f628a_y918.jpg?direct&400 |}} | {{ :project:amiga_ps2usb_mouse:pickit_pic16f628a_y918.jpg?direct&400 |}} | ||
| + | |||
| + | I used for programming SW: MPLAB X IDE v5.50. In setup choose MPLAB IPE as this part of SW is intended as standalone simple application for programming. | ||
| + | There can be some issues. For example I used previously some programming adapter connected to PICkit. Jumpers were set correctly, but PIC MCU had higher temp and I got error: Target Device ID (0x3fe0) is an Invalid Device ID. Please check your connections to the Target Device. After several hours of suffering and finding the cause of the problems, I gave up on the adapter and connected the MCU to the breadboard. | ||
| + | |||
| + | The right log from programming is following: | ||
| + | <code> | ||
| + | Verifying... | ||
| + | |||
| + | The following memory areas(s) will be verified: | ||
| + | program memory: start address = 0x0, end address = 0x7ff | ||
| + | configuration memory | ||
| + | EEData memory | ||
| + | User Id Memory | ||
| + | |||
| + | Verification successful. | ||
| + | Loading code from D:\...\ps2m_aminet\ps2m\pic\ps2m_5button.hex... | ||
| + | 2021-08-19 17:50:36 +0200 - Hex file loaded successfully. | ||
| + | 2021-08-19 17:50:41 +0200 - Programming... | ||
| + | |||
| + | |||
| + | Device Erased... | ||
| + | |||
| + | Programming... | ||
| + | |||
| + | The following memory area(s) will be programmed: | ||
| + | program memory: start address = 0x0, end address = 0x1f3 | ||
| + | Programming/Verify complete | ||
| + | 2021-08-19 17:50:47 +0200 - Programming complete | ||
| + | |||
| + | Blank Checking... | ||
| + | program memory | ||
| + | Address: 0 Expected Value: 3fff Received Value: 18b | ||
| + | Blank check complete, device is not blank. | ||
| + | </code> | ||
| + | |||
| + | Blank Checking was clicked additionally just for sure :) | ||
| + | |||
| + | ===== References ===== | ||
| + | Thx to Henryk Richter from http://bax.comlab.uni-rostock.de/en/hardware/ps2-amiga-maus/ | ||