Differences

This shows you the differences between two versions of the page.

--- project:amiga_ps2usb_mouse:amiga_usb_ps2_mouse [2021/08/19 18:31]
cyberian [PICkit v3.5 - programming kit]
+++ project:amiga_ps2usb_mouse:amiga_usb_ps2_mouse [2021/08/19 18:47]
cyberian [PICkit v3.5 - programming kit]
@@ Line 19: / Line 19: @@
 {{ :project:amiga_ps2usb_mouse:pickit_pic16f628a_y918.jpg?direct&400 |}}
+I used for programming SW: MPLAB X IDE v5.50. In setup choose MPLAB IPE as this part of SW is intended as standalone simple application for programming.
+There can be some issues. For example I used previously some programming adapter connected to PICkit. Jumper was set correctly, but PIC MCU had higher temp and I got error: Target Device ID (0x3fe0) is an Invalid Device ID. Please check your connections to the Target Device. After several hours of suffering and finding the cause of the problems, I gave up on the adapter and connected the MCU to the breadboard.
+The right log from programming is following:
+<code>
+Verifying...
+The following memory areas(s) will be verified:
+program memory: start address = 0x0, end address = 0x7ff
+configuration memory
+EEData memory
+User Id Memory
+Verification successful.
+Loading code from D:\...\ps2m_aminet\ps2m\pic\ps2m_5button.hex...
+-08-19 17:50:36 +0200 - Hex file loaded successfully.
+-08-19 17:50:41 +0200 - Programming...
+Device Erased...
+Programming...
+The following memory area(s) will be programmed:
+program memory: start address = 0x0, end address = 0x1f3
+Programming/Verify complete
+-08-19 17:50:47 +0200 - Programming complete
+Blank Checking...
+program memory
+Address: 0 Expected Value: 3fff Received Value: 18b
+Blank check complete, device is not blank.
+</code>
+Blank Checking was clicked additionally just for sure :)